amazing.
especially after a week of effort.
thank you.
dave
On Sat, Apr 22, 2017 at 12:30 PM, Dave Mallery dave.mallery@gmail.com
wrote:
Hi Mark
I was delighted to read about Heather's ability to talk to a timing M12.
I have been having fits here trying to get the M12 to accept any command
(using Perl.. a mistake it seems). i wanted to end up with a Linux capable
utility and had previously used Perl to parse NEMA on my old TAC2.
I have been learning about binmode(M12) and other edge cases, but am
probably still far from the eureka moment..
anyhow, i am setting up heather5 for a trial flight.
thanks
dave mallery
On Fri, Apr 21, 2017 at 8:40 PM, Mark Sims holrum@hotmail.com wrote:
Earlier somebody asked if these were M12's or M12T's. I powered mine
up and connected it to Lady Heather. It appears to be an M12T. It
responds to the survey and position hold commands and outputs the sawtooth
correction value. Also the hardware ID returned is P373T12T12.
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/m
ailman/listinfo/time-nuts
and follow the instructions there.
--
Dave Mallery, K5EN (ubuntu linux 16-10)
PO Box 15 Ophir, OR 97464
linux counter #64628 (since 1997)
--
Dave Mallery, K5EN (ubuntu linux 16-10)
PO Box 15 Ophir, OR 97464
linux counter #64628 (since 1997)
amazing.
especially after a week of effort.
thank you.
dave
On Sat, Apr 22, 2017 at 12:30 PM, Dave Mallery <dave.mallery@gmail.com>
wrote:
> Hi Mark
>
> I was delighted to read about Heather's ability to talk to a timing M12.
> I have been having fits here trying to get the M12 to accept any command
> (using Perl.. a mistake it seems). i wanted to end up with a Linux capable
> utility and had previously used Perl to parse NEMA on my old TAC2.
>
> I have been learning about binmode(M12) and other edge cases, but am
> probably still far from the eureka moment..
>
> anyhow, i am setting up heather5 for a trial flight.
>
> thanks
>
> dave mallery
>
>
>
> On Fri, Apr 21, 2017 at 8:40 PM, Mark Sims <holrum@hotmail.com> wrote:
>
>> Earlier somebody asked if these were M12's or M12T's. I powered mine
>> up and connected it to Lady Heather. It appears to be an M12T. It
>> responds to the survey and position hold commands and outputs the sawtooth
>> correction value. Also the hardware ID returned is P373T12T12.
>> _______________________________________________
>> time-nuts mailing list -- time-nuts@febo.com
>> To unsubscribe, go to https://www.febo.com/cgi-bin/m
>> ailman/listinfo/time-nuts
>> and follow the instructions there.
>>
>
>
>
> --
> Dave Mallery, K5EN (ubuntu linux 16-10)
> PO Box 15 Ophir, OR 97464
>
> linux counter #64628 (since 1997)
>
>
>
>
--
Dave Mallery, K5EN (ubuntu linux 16-10)
PO Box 15 Ophir, OR 97464
linux counter #64628 (since 1997)
