-
I have just acquired an E1938 and powered it up. It seems to work. I
see that it has 4 blinking board LEDs (green, red, yellow, yellow) and a
pushbutton switch at the end of the board opposite to the DB25 connector.
Can anyone point me to either the schematic for the board or what these LEDs
and pushbutton show or do?
-
Also, there is an "EFC" voltage ("3.69v") marked in magic marker on top
of the can. Can anyone point me to where I can learn what, if anything,
this voltage notation should be used for?
Many thanks.
Jim Robbins
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
You can find schematics and various info here:
<http://www.prc68.com/I/pdf/E1938pdfdocs.zip>
<http://www.prc68.com/I/HPE1938.shtml>
<http://www.leapsecond.com/museum/e1938a/>
On Thu, May 11, 2017 at 3:47 PM, James Robbins <jsrobbins@earthlink.net> wrote:
> 1. I have just acquired an E1938 and powered it up. It seems to work. I
> see that it has 4 blinking board LEDs (green, red, yellow, yellow) and a
> pushbutton switch at the end of the board opposite to the DB25 connector.
> Can anyone point me to either the schematic for the board or what these LEDs
> and pushbutton show or do?
>
>
>
> 2. Also, there is an "EFC" voltage ("3.69v") marked in magic marker on top
> of the can. Can anyone point me to where I can learn what, if anything,
> this voltage notation should be used for?
>
>
>
> Many thanks.
>
>
>
> Jim Robbins
>
> _______________________________________________
> time-nuts mailing list -- time-nuts@febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
