The time-nuts@febo.com (mailto:time-nuts@febo.com)  reformatted the
offset / phase noise  table so it became almost unreadable compared to the
original , sorry,

Ulrich

In a message dated 8/10/2016 8:00:28 P.M. Eastern Daylight Time,
time-nuts@febo.com writes:

Test Equipment Improvement

The  measurement of  the  100 MHz  XO was done on an improved  R&S  FSWPs.
Measured data is in the table  below:

XO  100  MHz

FSWP SN  101143
FSWP SN  101192
Offset
Phase  Noise in  dBc/Hz
0.1  Hz
-45.24
-49.11
1  Hz
-82.30
-82.33
10  Hz
-113.87
-113.74
100  Hz
-143.27
-141.61
1  kHz
-166.55
-167.26
10  kHz
-180.54
-186.91
100  kHz
-186.41
-195.43

time-nuts  mailing list -- time-nuts@febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the  instructions there.

Attached is a GIF of the table Ulrich wants to share.

Note time-nuts is a plain text mailing list so any rtf or html formatting is discarded.
On the bright side, PDF or data or image attachments are allowed with no problem.

/tvb

These seem extremely fantastic results for a 100 MHz oscillator. I am curious what the Po of the oscillators are Regards - Mike

Mike B. Feher, EOZ Inc.
89 Arnold Blvd.
Howell, NJ, 07731
732-886-5960 office
908-902-3831 cell

-----Original Message-----
From: time-nuts [mailto:time-nuts-bounces@febo.com] On Behalf Of Tom Van Baak
Sent: Wednesday, August 10, 2016 9:19 PM
To: Discussion of precise time and frequency measurement
Cc: enrico.rubiola@gmail.com
Subject: Re: [time-nuts] State of the art of crystal oscillator measurements

Attached is a GIF of the table Ulrich wants to share.

Note time-nuts is a plain text mailing list so any rtf or html formatting is discarded.
On the bright side, PDF or data or image attachments are allowed with no problem.

/tvb