Hi All,
I ordered two HP 5060-0258 extender cards from Tucker Electronics; they work.
One extender is not quite long enough to allow access to the socket contacts
with mini-grabbers, so I ordered two cards. One extender is long enough to
carefully slip a voltmeter probe onto the contact area and/or grab part leads as
required for test and alignment.
Does anyone else use one of these Guildline 9975 resistance bridges? If so, do
you use the DB-37 connector on the back to remotely read the switch positions?
Joe
On 1/18/2014 7:14 AM, Joe Hobart wrote:
Does anyone have or know where I can buy or borrow a 12/24 contact extender card
for the Guildline 9975? I have a single sided extender, but the signal
demodulator board requires a double sided extender. Of course, it is this card
that needs additional testing and possible repair.
Thank you,
Joe Hobart
Flagstaff, Arizona
Hi All,
I ordered two HP 5060-0258 extender cards from Tucker Electronics; they work.
One extender is not quite long enough to allow access to the socket contacts
with mini-grabbers, so I ordered two cards. One extender is long enough to
carefully slip a voltmeter probe onto the contact area and/or grab part leads as
required for test and alignment.
Does anyone else use one of these Guildline 9975 resistance bridges? If so, do
you use the DB-37 connector on the back to remotely read the switch positions?
Joe
On 1/18/2014 7:14 AM, Joe Hobart wrote:
> Does anyone have or know where I can buy or borrow a 12/24 contact extender card
> for the Guildline 9975? I have a single sided extender, but the signal
> demodulator board requires a double sided extender. Of course, it is this card
> that needs additional testing and possible repair.
>
> Thank you,
> Joe Hobart
> Flagstaff, Arizona
> _______________________________________________
>
