I need some parts to start repairs on a Fluke 5200A AC Calibrator that has suffered drop damage.

My immediate need is for

Spacer 10-32 by 0.5"    2 off (female/male)
#10, 0.031 washer      1 off
#10 split lock washer  1 off
Nuts 10-32 hex          2 off

My usual sources in the UK are no use at all as they only sell metric stuff.

Can anyone help with these?

If anyone has any of the plastic board locators used in the 5200A (yellow and white ones preferred though any colour will do).

I will also need some some 48/96 way dual readout 0.1" edge connectors.

Regards,
David Partridge

Oops - the edge connectors are 43/86, not 48/96.  They appear to be EDAC 345-086-520-201 with PC tails.

Regards,
David Partridge
-----Original Message-----
From: volt-nuts-bounces@febo.com [mailto:volt-nuts-bounces@febo.com] On Behalf Of David C. Partridge
Sent: 30 December 2011 14:59
To: 'Discussion of precise voltage measurement'
Cc: TekScopes@yahoogroups.com; hp_agilent_equipment@yahoogroups.com
Subject: [volt-nuts] Parts needed to repair Fluke 5200A AC Calbrator

I will also need some some 48/96 way dual readout 0.1" edge connectors.

Regards,
David Partridge

volt-nuts mailing list -- volt-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
and follow the instructions there.

A guy who's coming to collect a scope from me next week has offered to make up the mechanical parts in his machine shop, so I think I'm OK for the hardware ...

Thank you
David Partridge