Thanks, I will look on Tom's site for the manuals. The last time I looked
into this, I think all I saw were copper cavities.
But I think some sort of design that required very minimal machining, and
much more "plumbing", would be what I would need to do a homebrew maser :-).
Tim N3QE
On Tue, Jan 3, 2017 at 1:14 PM, cdelect@juno.com wrote:
Tim,
The EFOS2 uses an Aluminum cavity! So machining would be easier than
Copper!
The complete manuals with schematics are on Tom's Leapsecond.com site.
Making a homebrew Maser was bandied about a few years ago on TimeNuts.
Cheers,
Corby
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/
mailman/listinfo/time-nuts
and follow the instructions there.
Thanks, I will look on Tom's site for the manuals. The last time I looked
into this, I think all I saw were copper cavities.
But I think some sort of design that required very minimal machining, and
much more "plumbing", would be what I would need to do a homebrew maser :-).
Tim N3QE
On Tue, Jan 3, 2017 at 1:14 PM, <cdelect@juno.com> wrote:
> Tim,
>
> The EFOS2 uses an Aluminum cavity! So machining would be easier than
> Copper!
>
> The complete manuals with schematics are on Tom's Leapsecond.com site.
>
> Making a homebrew Maser was bandied about a few years ago on TimeNuts.
>
> Cheers,
>
> Corby
>
> _______________________________________________
> time-nuts mailing list -- time-nuts@febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/
> mailman/listinfo/time-nuts
> and follow the instructions there.
>
