Sent from iPad Air
Hi
That’s likely a “better” antenna for a TBolt-only setup than the L1 / L2 gizmo that
we have been chatting about. Why?
if it’s still $25 it would be ~ 1/4 the price
it has a pretty good filter built into it.
it’s designed for continuous outdoor use (connector is well shielded etc)
It’s smaller and easier to mount
Lots to like.
Bob
On Feb 6, 2018, at 2:45 PM, Gregory Beat w9gb@icloud.com wrote:
Sent from iPad Air
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
On Tue, 6 Feb 2018 14:54:23 -0500, you wrote:
That's something that has always baffled me - the number of antennas
which the manufacturers claim are suitable for long term outdoor use
that have connectors which are impossible to seal without large
quantities of sealant or whatever.
Angus.
On 06/02/18 22:21, Angus via time-nuts wrote:
On Tue, 6 Feb 2018 14:54:23 -0500, you wrote:
That's something that has always baffled me - the number of antennas
which the manufacturers claim are suitable for long term outdoor use
that have connectors which are impossible to seal without large
quantities of sealant or whatever.
Generally speaking, you can seal most RF connectors quite nicely with a
few layers of self-amalgamating tape and a layer of PVC tape over the
top of that (to protect from UV).
Practically speaking, if the antenna is mounted on the top of a pole,
95% of the rainwater is going to run down the side of the antenna and
drip off the edge (assuming something shaped roughly like a PCTel 26dB
timing antenna). The seals are more use if the antenna is mounted on a
flat surface.